Insert the prepared plug in the crimping tool and squeeze the handle crimping the wires.
Cat 5 cable crimping instructions.
This would work for any cat5e and cat6 cable.
Strip the cable back 1 inch 25 mm from the end.
Thank you for checking out my first video.
With the head positioned properly apply pressure to the crimper s handles to clamp the head down onto the wires.
The metal contacts should now be touching each of the 8 wires.
Insert the cable into the stripper section of the tool and squeeze it tight.
If it is longer than 1 2 it will be out of spec and susceptible to crosstalk.
Wire and cable.
Rotary coaxial cable stripper.
The copper splicing tabs on the connector will pierce into each of the eight wires.
There is also a locking tab that holds the blue plastic sleeve in place for a tight compression fit.
Typically i actually squeeze the cable in the crimping tool twice.
Crimp the head onto the cable.
Ethernet has been taking over the world for the last few decades.
High leverage linesman pliers with crimping tool.
Flatten the end between your thumb and forefinger.
Trim the ends of the wires so they are even with one another leaving only 1 2 in wire length.
The crimping tool will have a section with a razor blade and enough clearance to cut through the jacket but not the wires on the inside.
Place the plastic head into the appropriate slot in the crimping tool being careful not to dislodge the 8 wires.
Place the cable in this slot gently squeeze the crimping tool and rotate it to cut all the way around the jacket.
Rotary coaxial cable stripper 7 97.
Klein tools d2000 9necr at 47 48.
Carefully place the connector into the ethernet crimper and cinch down on the handles tightly.
Rj45 connectors have been used for phone and ethernet connections for a long time but their original development.
High leverage linesman pliers with crimping tool 17 99.
Wire and cable stripper.
After that you can pull off the jacket to expose the smaller wires inside.
In store only add to my list.
Then rotate the crimping tool around the cable in a smooth and even motion to create a clean cut.
Keep the tool clamped and pull away towards the end of the wire to remove the sheathing.
Spread untwist the pairs and arrange the wires in the order of the desired cable end.
